With the car now totally clean and free from contamination and oils, it's time to seal the paint.
Beaut Beads is a high end paste wax that is super easy to apply and remove, creates a fantastic glow and gives remarkable depth and shine to your paint, as well as excellent water beading and self cleaning properties.
Grab your Beaut Beads jar and applicator. Place the applicator into the jar with the soft foam side facing down (this will be your application side). Gently twist the applicator side to side a few times, to get some wax on the applicator. You can start off on any section you like (just be methodical) using the applicator in an up and down direction in a small section, then go over the same section in a side to side motion (the opposite way) to ensure complete coverage of the area with the wax. When you apply the Beaut Beads paste wax, less is more - the thinner and more evenly you can apply the product, the better the result you will get, and your overall experience will be a lot nicer (having said that, even if you pile it on thick, this wax is still an absolute dream to remove).
For any more intricate areas like around door handles, wing mirrors, grills, badges etc, there is a smaller foam applicator in the Beaut Beads box that is perfect for these areas.
Avoid getting Beaut Beads on any exterior plastics, as it can leave white marks. If you notice this, use the Flash Prep and a cloth straight away to remove it.
Go around and apply Beaut Beads to the entire car, then leave it on the car to cure and bond for 20 minutes. After this cure time, gently buff off the remaining residue with a Drop Bear cloth, flipping and turning the cloth often as you go. If you notice the cloth start to fill up with wax, switch to a fresh cloth.
Leave the wax now to cure and harden for at least 4 to 5 hours before getting it wet or applying any other products over the wax. Ideally, it should cure and harden for 12 hours (overnight) at least before washing the car again.