Wet Dreams
Application method 1:
This is for the first time application of the product to your 4x4, or if you don’t use a pressure washer:
1. Wet and then wring out a Big Softie microfibre cloth. Work on one wet panel area at a time, evenly mist Wet Dreams in a sweeping motion over the entire surface.
2. Gently wipe over in a back and forth methodical action to get an even coverage. (Continue to wring this cloth out between different panels/sections as well).
3. IMMEDIATELY rinse off thoroughly with a strong jet of water in a methodical side to side motion, being sure to rinse any glass and adjoining panels that might have gotten overspray on them as well.
The bead porn effect is activated by friction from the strong jet of water over the surface. You'll notice the beading will get better over the next 10 to 15 minutes as the product cures on the surface. If you wish for more water beading after the first application, re-apply to the areas that need it for complete satisfaction.
Once done, rinse out the Big Softie cloth and then put it into a bucket of clean water. Machine wash it in our Microfibre Wash with the Big Green Sucker and other cloths once you're all packed up and finished. You don't want this towel to dry with product in it, otherwise it will become super hydrophobic as well.
Application method 2:
This method is best if you're using a pressure washer and also great for touch-less use or quick top ups:
1. Work on one wet panel at a time, mist the Wet Dreams in a sweeping, even motion across the entire surface.
2. IMMEDIATELY rinse thoroughly with a pressure washer or hose, being sure to rinse any glass and adjoining panels that might have gotten overspray on them.
3. Work right around the car till you're finished. The bead porn effect is activated by the friction from the strong jet of water over the surface. You'll notice the beading will get better over the next 10 to 15 minutes as the product cures on the surface. If you wish for more water beading after the first application, re-apply to the areas that need it for complete satisfaction.
With this method you will use more product over the spray and wipe/spread method mentioned above. However, it can be handy if you're using the Happy Ending finishing foam, as this way is faster and easier to quickly boost smaller sections between its applications. Just spray it on the areas the beading is reduced and then pressure wash or hose it off.
On the slight chance that you get any streaking or uneven patchiness when using this method, simply wipe over the marks with the Big Green Sucker or Big Softie cloth using a little bit of extra pressure on the towel to remove these "high spots". If the marks are left to dry, don't freak out as the Paint Cleanse and Restore can remove them easily.
Now use the new found surface tension to help dry your 4x4. Do this by taking the end off your hose and flooding the panels with water, sheeting the majority of the water droplets from the now coated surface. Refer now back to the "Drying" section of this article above.
See our detailed guide and video below for using Wet Dreams:
