Super hydrophobic protection with Happy Ending

Happy Ending was made to quickly give a visible boost of protection to the car at the end of a wash, as well as creating a super high gloss and slippery smooth finish. All this happens from simply spraying it on, and then pressure washing it off, to leave a super hydrophobic coating, before drying the car as you do in a normal wash.

1. Mix the Happy Ending in a Snow Blow Cannon bottle (a separate Happy Ending labeled bottle is available - part code to order one from our resellers is BOHCB). It handily uses the same dilution ratio of 9:1 as the Summer Snow foam. Add 900mL of fresh water, before turning the Happy Ending bottle upside down above the cannon bottles inlet and open the pop top, to ensure there is no wasted product when filling. Add 100mL of the Happy Ending using the measuring marks on the cannon bottles label. 

2. Carefully screw the Happy Ending mixture bottle to the cannon unit and attach to your pressure washer. Adjust the cannons top air knob to full clockwise (-) and adjust front nozzle to give a medium arc, a little bit wider than you would use with the snow foam.

3. Apply the light foam to the roof and then work to the bottom. It's safe for all glass, exterior plastic trims, wheels and tyres. Slowly walk around the entire car till it’s covered. Note that this product doesn’t create a thick foam. Do your best to try and avoid applying directly to the windscreen. On larger vehicles like trucks and vans, or in warmer conditions, we recommend that you do half the vehicle at a time.

4. Once finished, quickly remove the cannon from the lance and change to the lances power wash fitting. Immediately begin to THOROUGHLY pressure wash the product off, especially on the glass. Start from where you began applying using a methodical, overlapping motion from the top of the car to the bottom, doing a couple of passes over each section to activate the bead porn. The bead porn effect is activated by the friction from the strong jet of water over the surface. You'll notice it gets better over time as the product cures on the surface. Work right around the car till you're finished. If you wish for more water beading after the first application, re-apply as per above to the separate areas for complete satisfaction. 

5. Now use the new found surface tension to help dry your vehicle. Do this by taking the end off your hose and flooding the panels with water, sheeting the majority of the water droplets from the now coated surface so there's less water to dry.