Instructions for use - Spray on method

This first way of using Three Way is very simple. We recommend this method if you have very light contamination.

Step 1: 

Wash and dry the vehicle safely. We'd recommend to wash with one of our lubricating washes; Nanolicious Wash, Wax Wash or Auto Body Gel using one of our safe microfibre wash tools like our Wash Pillow or Shagamittastic Wash Mitt. We recommend to use a double solution of your favourite wash to make sure you're getting rid of as much dirt, oils and grease as possible. After you've washed the vehicle, dry it safely with the Big Green Sucker. Don't use any Boss Gloss or other detailing sprays on your Big Green Sucker during this drying process, as it can affect the next steps, and it'll also be a waste of product!

 

Step 2:

Make sure the vehicle you're decontaminating is in the shade and the paint is cool to touch. A well ventilated area outside in the shade is ideal.

Spray Three Way directly onto the painted surfaces (don't stress if you get it on headlights, plastics etc, as it's 100% safe for all of these surfaces), 1 panel at a time, and allow 1 minute for the purple reaction to begin. This reaction is the ingredients in Three Way reacting with the iron particles on your paint, and safely breaking them down so they can be rinsed away. You will notice this reaction will be stronger on the bonnet, roof and rear of the car, as these are the panels that will see most of the fallout on them through normal use.

 

Step 3:

After 1-2 minutes (no more than 3-4 minutes), rinse the panel thoroughly. If you're worried about water drying on the panels, dry the panel before moving on. Move onto the next panel and use the same method on each subsequent panel, until the whole car is done.

 

Step 4:

Spray a small section that you have already done (the bonnet is always a good judge), to see if you get any further reaction. If you do, then you may need to do another application over the vehicle, or, use our more effective and deeper decontamination method using the Claying Rubber, as outlined below.

If you don't get any further reaction, wash and dry the vehicle again. You're now ready to use Paint Cleanse & Restore to deep clean the paint and prepare it for our other wax and sealant products.