Paint Cleanse & Restore
With the claying step done, now you want to deep clean the pores of the paint to prepare the surface for the Beaut Beads wax. Paint Cleanse & Restore gets deep into the undulations of the paint and cleans deep embedded dirt, leaving a perfectly clean finish, ready for waxes and sealants.
Grab the Paint Cleanse & Restore and a Circle Work applicator pad. Shake the bottle well and add a 50c sized dollop of the Paint Cleanse & Restore to the centre of the pad, and wipe it into the surface of the pad with your finger, to ensure there are no dry spots for starting the process.
Working on smaller sections at a time (similar to the clay bar - break the bonnet up into 4 parts, for example). Using some gentle pressure, work the product into the paint with the pad in an up and down motion, then side to side over the same section, to ensure you don't miss any bits. You'll notice the Paint Cleanse & Restore will begin to go opaque, before going clear after a short work time. Once it's gone clear, it's done all the cleaning it's going to do, so it's time to wipe off.
Using a clean, dry and folded Big Softie cloth (folded to the low pile side), gently buff off the remaining Paint Cleanse & Restore residue, flipping the cloth to a fresh side as needed.
For the next section, and subsequent sections, only add a small amount more of the Paint Cleanse & Restore as needed (usually a smaller 5c or 10c sized dollop will be needed for each new section).
If you have any problems removing the Paint Cleanse & Restore with the cloth after application, spray 1-2 sprays of Boss Gloss straight onto the part that is difficult to remove, then buff off immediately with a Big Softie cloth.