Snow foaming

Your kit contains adapters for the Karcher K series, and Gerni/Stihl/Husqvarna/Nilfisk pressure washers. We have 8 other adapters to suit a wide variety of machines available on our website. Check our guide below for more information on this, or if you require a different adapter. All the information you need to get the adapter you require is in this article.



Fill your Snow Blow Cannon bottle with 900mL of water and 100mL of Snow Job, attach it to the cannon and give it a good shake. Attach it to your pressure washer handle where the lance extension disconnects from the gun, turn the knob almost all the way to the "-" side, adjust the fan so you get a good arc, then move to the back of your vehicle. Starting at the bottom, begin foaming the car in a methodical overlapping motion, moving round the car till complete.

Allow the Snow Job to dwell for 3-5 minutes (less if you're in the sun - don't let it dry) and then begin thoroughly pressure washing the foam off, starting from the roof, and leaving the lower rear sections till last - this gives the foam the maximum dwell time so that it can break down and remove as much grime as possible. Use overlapping sweeping motions, breaking the car down into sections (e.g one door, one rear section etc).

More tips for using the Snow Blow Cannon and snow foaming can be found here: