Supercheap Auto - Aussie Holiday Detailing Kit

Wheely Clean

Half fill your Wheels bucket with water (Wheels bucket is available separately), then add a capful of Red Stuff and froth the mixture up inside the bucket with a short blast from the pressure washer to properly mix it up. If you don't have a pressure washer, use the "Jet" setting on your hose end.

With your Wheels bucket set up next to the wheel, and with your brushes handy in the bucket, spray the Wheely Clean directly onto the wheel. Leave it to dwell for only a short time (30 seconds or so), then scrub the wheel with the Little Chubby brush. If you'd like to clean the inside barrel of the wheel, use the Flat Head brush, and get in there around the inside of the wheel barrel. Rinse the brushes out in the Wheels bucket as needed.

For the smaller or intricate areas around the wheels (wheel nuts etc), use the Nuts and Guts brush from the Foursome brush set, which is available separately.

Once the wheels and tyres have been cleaned, you can spray a few sprays of Green Dreams straight onto the wheel face, then pressure wash or hose it off, to add some super easy protection and a lovely shine in one step. This will make it more difficult for brake dust to stick to the surface, making your next wash just that little bit easier.

For a detailed guide on wheel cleaning, see our guide below:

 

Adding the shine with Boss Gloss

Boss Gloss can be used as a drying aid with the Big Green Sucker, or as a standalone detailer to add a brilliant shine to your paintwork. Grab two folded Drop Bear towels, and spray 8-12 sprays into one side of the first cloth. Then gently wipe over the vehicle in a section at a time (e.g a door, half the bonnet). Grab your second clean and dry Drop Bear and immediately buff off to reveal a beautiful shine and slick feeling. Continue round the car till it's all finished. Check out our full guide for Boss Gloss here:

Glass Cleaning with Naked Glass

For the best glass cleaning experience, we recommend using Naked Glass with our specialised glass cleaning cloth; the Inta-Mitt.

Use 1-2 sprays only of Naked Glass into the green side of the Inta-Mitt (if it's cold, use less, and if it's warmer, you may need to use a little more Naked Glass). Gently wipe up and down, then back and forth over the glass until you see any marks in the glass disappear and the Naked Glass start to flash off. Turn the Inta-Mitt to the purple side and gently buff over the entire glass surface to remove any remaining product and to remove any haze from the glass.

If the glass is very dirty, or you have stubborn marks on there, you can spray the Naked Glass directly onto the glass, leave it for 10-15 seconds before using the Inta-Mitt in the same way as described above.

For a more in-depth look at glass cleaning and the Inta-Mitt, see our article below: